Skip to content
TestHive
End-of-line testing

End-of-line   testing   for   electronic   boards

Every board that leaves the line is powered, measured and checked against its limits, and the result stays tied to its serial number. TestHive runs that test on your bench.

01

Where manual end-of-line testing falls short

A manual check depends on who runs it: the order of the steps, the readings written down, the limits applied. When a board comes back from the field, the question is what was measured on that unit, and a paper sheet or a spreadsheet rarely answers it.

02

The test as a graph you can read

Each test is a graph of steps: set a supply, read a meter, send a CAN frame, check a value against its limits, capture an image. You build it in a visual editor; branches, loops and parallel steps are part of the graph, and the file it saves is plain JSON you can keep under version control.

03

Your instruments, your fixture

TestHive drives SCPI instruments, CAN and CANopen through PCAN adapters, RS232/RS485 serial lines and the I/O of a custom fixture. Instrument drivers are separate components: supporting a new instrument does not take a new version of the application.

04

One bench, one operator

It runs on the bench PC, for the operator in front of it: the runner shows the steps, the live readings and the pass/fail outcome of each board. It installs without an IT department and updates itself.

05

The history of every board

Results are stored by product, batch and serial number, so every unit carries its own record of what was measured on it. Reports in PDF, HTML, CSV or Excel are produced from that record whenever you need them, with your own branding.

All the features

Get early access

TestHive ships in 2026. Join the early-access list for a seat, product updates and launch pricing before public release.

No spam. To leave the list, write to info@nexilica.com.